R: Morrow Designs Micro-Menu system - Rev 3.0 (HARD DISK)
R: Module - INIT.PIL
R: Copyright 1982, 1983 Morrow Designs, Inc.
R: All Rights Reserved
R: Written by Harrison Schreppel for Morrow Designs
R: Modified by John VanderWood for MD-11
R:
CLRS:
LF:7
T:
T:   Congratulations on getting an MD-11.  Since this is the first time you
T:   have used this machine, certain things must be done before you can put
T:   it to work.  Most of what is about to be done is  automatic.  It takes
T:   about 15 minutes.  Just follow the instructions  as they appear on the
T:   screen.
T:
T:   During transportation, too much  vibration of the hard disk  sometimes 
T:   causes information recorded on the hard disk to change.  I'm going  to 
T:   run a quick test now to make sure everything's still OK.
T:
T:   This takes a little time, so please be patient.
T:
WAIT:
CLRS:
CPM:VERIFILE;
C:FAIL=@64
J(FAIL):*ER
J:*AP
*ER
CLRS:
LF: 3
T:  }Unfortunately, I found some errors when testing your hard disk.  There-
T:   fore we have to replace the information  on the hard disk.  Putting the 
T:   information back on the hard disk from your floppies  is a simple semi-
T:   automatic procedure. 
T:
T:   To begin, find the diskette labelled:
T:
T:                   {CP/M DISTRIBUTION MASTER DISKETTE I
T:}
T:   and insert it in the floppy disk drive.  Remember to close the latch on
T:   the drive.  Do this now.
T:
T:   In a moment you'll press the RESET button on the lower righthand corner
T:   of the MD-11's  front panel.  On the screen you'll see: {Do you want to 
T:   boot  from the floppy drive (Y/N)?}  Respond {Y}.  An automatic program 
T:   will lead you through inserting the rest of your Distribution Diskettes
T:   so they can be copied  onto the hard disk.  When that's finished,  this 
T:   program will start again, and should not find any problems this time.
LF: 2
TNR:               {When you're ready, press the RESET button.  }
HOLD:
*INF
J:*INF

*AP
CLRS:
LF:10
T:  Good news!
T:  Your hard disk appears to have survived its journey unscathed.
T:
T:  Now the next step: installing your programs for your particular system.
TNR:  Type any key to begin:  
INMAX: 1
A:
CH: go.pil