R: Morrow Designs Micro-Menu system - Rev 2.5
R: Module - INIT.PIL
R: Copyright 1982, 1983, 1984 Morrow Designs, Inc.
R: All Rights Reserved
R: Written by Harrison Schreppel for Morrow Designs
R: Modified by John VanderWood 3/27/84
R:
CLRS:
T:{
T: Congratulations!}
T:
T: You have successfully installed CP/M for your Micro Decision.   But you are
T: not done yet.  Before you can use any of the application programs provided, 
T: (such as NewWord or Supercalc),  you need to create working diskettes which
T: contain these programs.    This is normally done by using the {Create Work- 
T: ing Diskettes}option that follows.  You can  create some working  diskettes 
T: now and others later,  if you like.  The  Create Working Diskettes function 
T: is always available on the Co-Pilot Utility Menu.
T:
T: {*************************************************************************
T:  *                                                                       *
T:  *                               WARNING!                                *
T:  *                                                                       *
T:  *       Attempting to use the supplied application programs without     *
T:  *       creating working diskettes will cause improper operation of     *
T:  *       of these programs.                                              *
T:  *                                                                       *
T:  *************************************************************************}
T:
TNR: Press{[RETURN]}to continue: 
A:
CLRS:
T:      Before  creating your Working Diskettes, the Micro Decision needs 
T:      to know a few things about your printer.
T:
T:      There are two types of printers, parallel and serial.
T:
T:         {Your  system  is currently  set up for  a  parallel  or 
T:          centronics-type  printer.   If you are using a parallel 
T:          printer,  press}C{to proceed with creating your Working 
T:          Diskettes.} 
T: 
T:      If you are using a{serial}printer,  the Micro Decision will  need 
T:      to know its baud rate and type of handshaking. If you do not have 
T:      a  printer or you do not know this information,  you can postpone 
T:      entering this information now by pressing{C}. You will still need 
T:      to  run  the program{SETUP}before you  can  print  anything.  See 
T:      Appendix D of the Micro Decision User's Guide for instructions.
T:
T:      If you know your printer baud rate and handshaking type,  you can 
T:      run{SETUP}right now and get that out of the way.
T:
T:
*again
CUR:0,22
TNR:      Press{S}to run SETUP or{C}to Create Working Diskettes: {
INMAX: 1
A:
M: S , C
tnr:      
jn:*again
m:S
jn:*next
TNR:{
CPM:SETUP|
*next
CLRS:
LF:10
T:{Please stand by. . .
CH:CPMENU
END: