ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄĶ ARCMASTER NEWS ÇÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

   A TSR version of AM!!???  Read on!

   A TSR utility that permits calling ArcMaster from within a non-
   graphics application program is NOW AVAILABLE.  POPAM has the
   following features:

              - Requires only 6,480 bytes of normal RAM.
              - Cannot be called from the DOS level.  Must be
                called from inside an applications program.  If you
                are at the DOS level, you can run AM normally.
              - AM.EXE must be in the DOS path.
              - Will use EMS or DISK to swap in/out.  The amount
                of swap space required is dependent upon the size
                of the applications program running at the time
                POPAM is called.
              - Configurable "hot key".
              - Almost instantaneous swap with adequate EMS.  Disk
                swaps may require 5 or more seconds but that is much
                faster than leaving the applications program and
                executing AM, quitting AM, and returning to the
                applications program.
              - Absolutely requires DOS 3.0 or later.
              - When AM loads, it will have approximately 11K less
                RAM available than if executed normally from the DOS
                command line.

      Currently registered users may acquire POPAM for $10.00.  This is
      a limited time offer which will expire October 15.

      New registrants will be able to purchase AM and POPAM for
      $50.00.  POPAM will be mailed on diskette to those who purchase it.
      It is NOT Shareware and is not available for downloading from the
      BBS.