20
d:\pcb\logs\caller
NONE
NONE
d:\pcb\gen\doors.lst
PRODOOR
bull\bull4
bull\bull4g
bull\bull5
bull\bull5g
bull\bull7
bull\bull7g
bull\bull8
bull\bull8g
Z
-------------------------
Line 1 = Offset for Callers per hour.  If the graph maxes out, increase
         this number by 10's.
Line 2 = Path and filename for Node 1 callers log to process
Line 3 = Path and filename for Node 2 "                      ". or NONE.
Line 4 = path and filename for Node 3 "                       ". or NONE.
Line 5 = Path and filename for doors.lst file to process
Line 6 = Door to skip (such as a subboard, or adult game). If none type NONE.
Line 7 = Path and filename for (Ascii General graph)
Line 8 = Path and filename for (Ansi General graph)
Line 9 = Path and filename for (Ascii Calls/hour graph)
Line 10 = Path and filename for (Ansi Calls/hour graph)
Line 11 = Path and filename for (Ascii Door Use graph)
Line 12= Path and filename for (Ansi Door Use graph)
Line 13= Path and filename for (Ascii Zmodem/Puma graph) *
Line 14= Path and filename for (Ansi Zmodem/Puma graph) *

* The Zmodem /Puma graph will only be created if 
it correctly updates your callers log with the 
transfer speed.  Also, your protocol letter choices would have
to be Z for zmodem, and P for Puma.  Even if you do not use 
prodoor, or Zmodem/Puma you MUST specify a filename here even
though the file will never be created.

Also, please report any errors other 
than ERROR 5, to:

    D and D Software
    1603 N Maple St
    N Little Rock, AR 72114

   BBS (501) 374-8468