ECHO OFF
c:
CD\TAPE2BBS
DOORWAY SYS /S:[PATH TO DOOR.SYS] /K240 /T^C /PTAPE2BBS.EXE TAPE1.CFG
F:
CD\TAPE
CALL c:\bat\ANYNAME.BAT
:----------------------  Delete this line and all below before running

Line #1:  Turn Echo Off (optional)
Line #2:  Change to drive where TAPE2BBS is located.
Line #3:  Change to directory where TAPE2BBS is located.
Line #4:  This is a typical Doorway installation.  Some variation may
          occur due to differences in hardware and BBS software.
          If you are running a multi-node system, you will want to have a
          separate config file for each node.  The main reason is that, due
          to the design of the drives, you may only access the drives from
          the node on which they are located.
          Nodes without the drive will have to access the door in OFFLINE
          MODE. OFFLINE.BAT will be created and appended to so that you may
          restore the files during an event.
Line #5:  Change to drive where tape drive software is located.
Line #6:  Change to directory where tape drive software is located.
Line #7:  CALL batch file created by TAPE2BBS.  The name and location of
          the batch file will be as specified in your configuration
          file.  Note that if it is in your Dos path, you will not need
          to specify drive/path location.