B>@!*>@ ~!9"j1!w# xR*.l@)ʲ02B Little Board ID = , must = 7 to run this utility.<B AMPRO Hard Disk Auto-Boot Installer Copyright (C) 1985 AMPRO Computers, Inc. Version 1.2 This utility will install your current hard disk configuration on the system tracks of the SCSI hard disk drive located at SCSI ID 0, LUN 0. Prior to using this program you must use SYSGEN to write the proper size CP/M system to the system tracks of the SCSI hard disk drive from which you will boot. In addition, you must have already used the HINIT and SWAP utilities to customize your system. NOTE: The CP/M system you install on the hard disk must identical to the system you are running now. WARNING!!! As a safety measure, be sure to backup your hard disk before you perform this function or attempt hard disk auto-booting! Do you wish to continue? (Y/N) u_Y<>2d!d>ͨ>ʛ!ʛB Valid Boot sector not present on hard disk, do SYSGEN, HINIT, and SWAP, then retry.<!›~#fo"*."@." ͟"!"#@͇ ~#fo~)*B Run HINIT and SWAP to set up your system first. <*.P ~#fo"+͟"P"3 ~#fo~";!w# xr!?> 2d>!dͨ> 2d>2g!d >ͨB Done! You may now boot from hard disk. < 7026 7 027B SCSI read/write error, Sense byte = *jNx~ T#~C{YY